Arare is the Japanese word for hail, and it is also the name of the small, crunchy rice crackers it inspired. Look at the blade of this bunka and the name makes sense: the stainless cladding is covered in an irregular hammered tsuchime pattern that looks like a scattering of hailstones, and those small dimples help break the suction between blade and food so slices fall away cleanly. The Shibata Arare SG2 Bunka 170mm is a collaboration: the blades are forged by blacksmiths in Takefu, then sharpened, finished, and assembled by Takayuki Shibata and his team in Fukuyama, a shop famous for thin, wickedly sharp SG2 knives.
The core is SG2 (R2), a powdered stainless steel hardened to about 61 to 62 HRC, so it takes a very fine edge, holds it far longer than ordinary stainless, and will not rust or react with acidic foods. Shibata gives it an ultra thin laser grind behind the edge for clean, low effort cuts through dense vegetables, and the spine and choil are chamfered so the knife is comfortable in a pinch grip during long prep sessions. The bunka profile pairs a fairly flat edge for push cutting and chopping with an angled, clipped tip for scoring, mincing herbs, and fine detail work, all in a compact size that suits smaller boards. An octagonal rosewood handle gives the knife a warm, classic look.
Care Instructions: SG2 is a fully stainless steel and resists rust, but at 61 to 62 HRC the thin edge is hard and can chip if it meets bone, frozen food, or a twisting cut. Use wood or rubber cutting boards, hand wash and dry the knife after use, and keep it out of the dishwasher. Sharpen on quality water stones; SG2 is easier to sharpen than most powdered steels, and a few passes on a strop between sharpenings keeps the edge crisp.
Each knife is made by hand so measurements may vary.
The core is SG2 (R2), a powdered stainless steel hardened to about 61 to 62 HRC, so it takes a very fine edge, holds it far longer than ordinary stainless, and will not rust or react with acidic foods. Shibata gives it an ultra thin laser grind behind the edge for clean, low effort cuts through dense vegetables, and the spine and choil are chamfered so the knife is comfortable in a pinch grip during long prep sessions. The bunka profile pairs a fairly flat edge for push cutting and chopping with an angled, clipped tip for scoring, mincing herbs, and fine detail work, all in a compact size that suits smaller boards. An octagonal rosewood handle gives the knife a warm, classic look.
Care Instructions: SG2 is a fully stainless steel and resists rust, but at 61 to 62 HRC the thin edge is hard and can chip if it meets bone, frozen food, or a twisting cut. Use wood or rubber cutting boards, hand wash and dry the knife after use, and keep it out of the dishwasher. Sharpen on quality water stones; SG2 is easier to sharpen than most powdered steels, and a few passes on a strop between sharpenings keeps the edge crisp.
Each knife is made by hand so measurements may vary.
- Brand: Shibata
- Line: Arare
- Forged In: Takefu, Japan
- Sharpened and Finished By: Takayuki Shibata, Fukuyama, Japan
- Construction: San Mai, Hammer Forged
- Edge Steel: SG2 (R2) Powdered Stainless Steel
- HRC: 61-62
- Cladding: Stainless Steel
- Finish: Tsuchime (Hammered)
- Profile: Bunka (Angled K-Tip)
- Edge Grind: Even (50/50), Double Bevel
- Spine and Choil: Chamfered
- Handle: Octagonal Rosewood




